This is a highly accurate tachometer that is ideal applications requiring high-precision measurements. It has a large display and two smaller ones, allowing users to view "set points" at all times. It gives the user the flexibility to setup and monitor virtually any process, and works with any type of Shimpo sensor.
|Tachometer/rate meter||0 - 999999 with selectable decimal point|
|Elapsed time||0:00:00 - 9:59:59 or 0.00 - 999.99 sec|
|Process time||0:00:00 - 0:59:59 or 0.00 - 999.99 sec|
|Scalable||Yes (with outputs)|
|Accuracy (tachometer/rate meter and elapsed time modes)||± 0.008 % ± 1 digit|
|Display update time||0.2, 0.5, 1, 2, 5, 10, 15, 30, 60 seconds (selectable)|
|Time base||Controlled by a 16.000 MHz crystal|
|Display||6 digit 0.59" (15 mm) high LED (main), 2-6 digit 0.02" (6.5 mm) high auxiliary|
|Input no. of P/R||1 - 9,999 (programmable)|
|Input signal characteristics||NPN open collector input : max. frequency 100 kHz
Contact input : max. frequency 20 Hz
Square wave input : max. frequency 30 kHz
Sine wave input (magnetic pickup) : max. frequency 10 kHz
|Sensor power supply||12 VDC (150 mA)|
|Voltage requirement||85 - 264 VAC (50/60 Hz) (9-35 VDC at 1 W also available)|
|Ambient temperature||32° - 113° F ( 0 - 45° C)|
|Weight||0.66 lb (300 g)|
|Dimensions||5.27" L x 3.78" W x 1.89" H (92 mm x 96 mm x 48 mm)|
Shimpo DT-5TXR Panel Mount Tachometer is available with a DC power supply (DT-5XR-DC) or without.
The DT-5TXR has two connectors which can accept modules, cartridges which expand the functionality of the tachometer. These modules are designed to fit into the terminal block connector. For more information about these modules, see the DT-5TXR manual or give us a call or chat.
The 36-pin connector on the DT-5TXR is the other connector on this tachometer that takes modules. These modules are designed to fit into the 36-pin connector. For more information about these modules, see the DT-5TXR manual or give us a call or chat.
The DT-5TXR may be ordered with an optional LS-S50MLR sensor.